System Setup; Default Settings; Prerequisites; Operating Modes - Bosch DIVAR IP DIP-73GC-16HD Installation Manual

28 en | System setup
8

System setup

The DIVAR IP all-in-one 7000 systems are based on the operating system Microsoft Windows
Server IoT 2019 for Storage Standard. The operating system provides an user interface for
initial server configuration, unified storage appliance management, simplified setup and
storage management, and support for Microsoft iSCSI Software Target.
It is specially tuned to provide optimal performance for network-attached storage. The
Microsoft Windows Server IoT 2019 for Storage Standard operating system provides
significant enhancements in storage management scenarios, as well as integration of storage
appliance management components and functionality.
Notice!
This chapter is valid for DIVAR IP all-in-one 7000 models that come with pre-installed hard
i
drives.
The operating system of empty units loaded with third party hard drives will start normally,
but the added hard drives must be configured with the MegaRAID Storage Manager
application prior to initial software setup.
Refer to
–
8.1

Default settings

All DIVAR IP systems are preconfigured with a default IP address and with default iSCSI
settings:
–
–
Default user settings for administrator account
–
–
8.2

Prerequisites

Observe the following:
–
–
8.3

Operating modes

Operating modes
The DIVAR IP all-in-one systems can operate in three different modes:
–
–
2021.10 | V02 | DOC
Configuring hard drives using the MegaRAID Storage Manager application, page 29
IP Address: automatically assigned by DHCP (fallback IP address: 192.168.0.200).
Subnet mask: automatically assigned by DHCP (fallback subnet mask: 255.255.255.0).
User name: BVRAdmin
Password: to be set at first logon.
Password requirements:
– Minimum 14 characters.
– At least one upper case letter.
– At least one lower case letter.
– At least one digit.
DIVAR IP needs to have an active network link during installation. Make sure that the
network switch you are connecting to is powered on.
The default IP address must not be occupied by any other device in the network. Make
sure that the default IP addresses of existing DIVAR IP systems in the network are
changed before adding another DIVAR IP.
Full video recording and management system, utilizing the BVMS and VRM core
components and services: This mode allows for advanced video management features
such as event and alarm handling.
Pure video recording system, utilizing the VRM core components and services.
Installation manual
DIVAR IP all-in-one 7000 3U
Bosch Security Systems B.V.