Table of Contents
Advertisement
Configuring the Switch Modules using the Menu-driven Interface
The top line displays if IGMP Snooping is enabled or disabled globally on the switch
module.
If IGMP Snooping is enabled, you can set the following:
— Action—Toggle to Add/Modify.
— VLAN ID—Type the VLAN ID on which you want to enable IGMP snooping.
— State—Toggle to Enabled to enable IGMP snooping on the VLAN.
— Querier State—Toggle between Non-Querier, V1-Querier, and V2-Querier. This
— Robustness Variable—Enter a value between 2 and 255, with larger values being
— Query Interval—Enter a value between 1 and 65,500 seconds, with a default of
— Max Response—Set the maximum amount of time allowed before sending an IGMP
3. After making your changes, highlight APPLY, then press the Enter key.
IMPORTANT: To save the configuration settings permanently, you must enter them into NVRAM
using the Save Changes option on the main menu. Refer to the "Saving Changes" section earlier
in this chapter.
2-34
HP CONFIDENTIAL Codename: DeLorean Part Number: 322858-001 Last Saved On: 2/4/03 11:56 AM
setting is used to specify the IGMP version (1 or 2) that is used by the IGMP
interface when making queries.
specified for subnetworks that are expected to lose larger numbers of packets.
125 seconds. This setting specifies the length of time between sending IGMP queries.
response report. A value between 1 and 25 seconds can be entered; the default is
10 seconds.
HP ProLiant BL e-Class C-GbE Interconnect Switch Menu-driven Interface Reference Guide
Advertisement
Table of Contents
