Removing Power Supplies - HP ProCurve 9315M Quick Start Manual

CAUTION: Carefully follow the mechanical guides on each side of the power supply slot and make sure the
power supply is properly inserted in the guides. Never insert the power supply upside down.
4. Continue to slide the power supply towards the back of the chassis until the two metal rods and the connector
make contact with the back connector. Then push the power supply until the front panel of the power supply
is flush with the rest of the chassis.
5. Use a screwdriver to tighten the two screws on either side of the power supply.
6. Connect the power cord to the front of the power supply.
7. Connect the power plug into an outlet.
Figure 2.2 Installing a Power Supply

Removing Power Supplies

To remove a power supply module from the chassis, do the following:
CAUTION: Power supplies are hot swappable but they should be disconnected from AC power before being
installed or removed. That is, the Routing Switch can be running while a power supply is being installed or
removed, but the power supply itself should not be connected to a power source. Otherwise, damage to the
power supply or the Routing Switch could result.
Install the J4147A Power Supply only in the HP 9308M (J4138A) and HP 9304M (J4139A) Routing Switch
chassis. Install the J4875A Power Supply only in the HP 9315M (J4875A) Routing Switch. The J4147A and
J4875A Power Supplies are not interchangeable.
1. Unplug the power supply AC power cord from the outlet.
2. Disconnect the power cord from the power supply.
3. Use a screwdriver to loosen the screws on either side of the power supply.
4. Holding the bar on the front panel of the power supply, pull outward, disconnecting the power supply from the
backplane.
5. Continue to pull the power supply until it is removed from the chassis.
6. Place the power supply in an anti-static bag for storage.
7. Cover the power supply slot with the blank power supply cover that came with the device.
8. Use a screwdriver to tighten the screws.
Installation
2 - 9