JVC DLA-G150CLU Operating Instructions Manual page 35

Warning Messages
Message Cause
• When the DIGITAL ZOOM button
is pressed for the video signals
that cannot be zoomed (UXGA
60Hz, SXGA 60Hz.), this
message appears for a few
seconds to notify that the image
D.ZOOM
cannot be digitally zoomed.
* To forcibly clear the message,
press the EXIT button.
Displayed when the lamp control
setting is set to NORMAL MODE
• Appears every time the projector
is turned on after the lamp use
time has exceeded 900 hours and
until it reaches 1000 hours.
Lamp replacement
* The message is cleared by
EXIT
pressing any button.
Displayed when the lamp control
setting is set to NORMAL MODE
• When the lamp use time reaches
1000 hours, the word "Warning"
blinks on the screen.
Warning
* To cancel this message, press
Lamp replacement
the EXIT button.
EXIT
However, the same message will
appear every hour.
* If the power is turned off after the
lamp use time has exceeded
1000 hours, the power can not be
turned on again.
* When the lamp use time reaches
1010 hours, the projector is
forcibly turned off and can not be
turned back on again.
68
All manuals and user guides at all-guides.com
Corrective action Page
• Digital-zoom function does not 13, 37
work for the inputted video
signals.
To use the this function, input the
video signals that can be digitally
zoomed.
• Arrange for a new lamp (lamp 44, 46
unit) or replace the lamp early.
• Replace with a new lamp (lamp 44, 46
unit) and reset the lamp time.
Message Cause
Displayed when the lamp control
setting is set to LIGHT OUTPUT
CONTROL MODE (LOC) or LIGHT
POWER CONTROL MODE (LPC)
and the lamp use time display is
1000 h
turned [ON] with the OSD menu
Lamp replacement
• Displayed when the lamp use
EXIT
time exceeds 1000 hours.
* The message does not appear if
the lamp use time display is
turned [OFF] with the OSD menu.
Displayed when the lamp control
setting is set to LIGHT OUTPUT
CONTROL MODE (LOC) or LIGHT
POWER CONTROL MODE (LPC)
• Appears every time the projector
is turned on after the lamp use
Lamp replacement
time has exceeded 1900 hours
EXIT
and until it reaches 2000 hours.
* The message is cleared by
pressing any button.
Displayed when the lamp control
setting is set to LIGHT OUTPUT
CONTROL MODE (LOC) or LIGHT
POWER CONTROL MODE (LPC)
• When the lamp use time reaches
Warning
2000 hours, the word "Warning"
Lamp replacement
blinks on the screen.
EXIT
* To cancel this message, press
the EXIT button.
However, the same message will
appear every hour.
* If the power is turned off after the
lamp use time has exceeded
2000 hours, the power can not be
turned on again.
* When the lamp use time reaches
2010 hours, the projector is
forcibly turned off and can not be
turned back on again.
Memo
The message display language corresponds to the menu display language setting. This is set to "English (English)" when the
projector is bought. The display language can be selected from 6 languages. (Refer to page 46.) However, the input mode
(PC1, PC2, DVI, Y/C, VIDEO, COMP) and button indications (FREEZE, D.ZOOM, EXIT) are only displayed in English
irrespective of the display language setting.
The language settings in the section are explained in "English".
Warning Messages
Corrective action Page
• Arrange for a new lamp (lamp 44, 46
unit) or replace the lamp early.
• Arrange for a new lamp (lamp 44, 46
unit) or replace the lamp early.
• Replace with a new lamp (lamp 44, 46
unit) and reset the lamp use time.
69