Guarantee Statement - Hoover FR71FR03 User Manual

User Checklist
If your cleaner is not working properly run through the
following checklist.
1. Is there a working electricity supply to the cleaner?
Check with another electrical product.
2. Is the dust container full or choked with fine dust?
To empty the dust container, see instructions on P8.
3. Is the hose blocked?
To clear a blockage, see instructions on P10.
4. Is there a blockage in the cleaner base?
To clear a blockage, see the instruction on P10.
5. Are the filters blocked?
To clean filters, see the instruction on P9.
6. Is the nozzle height set correctly?
To set the carpet height selector, see the instruction on p5.
7. Are the brushes rotating correctly?
To check the brushes, see the instructions on p10.
8. Has the cleaner overheated?
If so, it will take about 30 minutes to reset.
If there is any doubt call the Hoover Service Office for advice. They may be able
to assist you over the telephone. A service charge will be made if the cleaner is
examined and found to be in working order, has not been assembled in accordance
with these instructions or has been used incorrectly. working order, has not been
assembled in accordance with these instructions or has been used incorrectly.
WARNINg!
A thermal cut out switches off the cleaner to prevent overheating if it is used
when full or there is a blockage or dirty filters. If this should happen switch
off, unplug and correct the fault.
It will take about 45 minutes for the cut out to automatically reset.
Do not run cleaner over the supply cord as this could damage
IMPORTANT:
the supply cord insulation.
Important information
Hoover Service
Should you require service at any time, please contact your local Hoover
Service Office.
Hoover spares and Consumables
Always replace parts with genuine Hoover spares. These are available
from your local Hoover dealer or direct from Hoover. When ordering parts
always quote your model number.
USE ONLY HOOVER SPARES
SPARE PARTS
PRE-MOTOR FILTER
EXHAUST FILTER
AGITATOR
BELT
HOSE
PET HAIR REMOVER NOZZLE
ALLERGEN REMOVER NOZZLE
PARQUET EXTRA NOZZLE & ADAPTER
Hoover's factories have been independently assessed for quality. Our
products are made using a quality system which meets the requirements
of ISO 9001

gUARANTEE STATEMENT

The guarantee conditions for this appliance are as defined by our
representative in the country in which it is sold. Details regarding these
conditions can be obtained from the dealer from whom the appliance was
purchased. The bill of sale or receipt must be produced when making any
claim under the terms of this guarantee.
Subject to change without notice.
11
CODE
S111 - 35601660
T95 - 35600835
Y202E - 35601613
V17 - 09161985
D102 - 35600836
J34 - 35600840
J33 - 35600839
G102PC - 35600888
Quality