Electrical Connection - Smeg C7GMXI8-2 Manual

Make the connection to the gas mains using a rubber hose
whose specifications comply with current standards (verify that
the reference standard is stamped on the hose).
Carefully screw the hose connector 3 to the appliance's gas
connector 1 (1/2" thread ISO 228-1), placing the seal 2
between them. The hose connector 4 can also be screwed to
the hose connector 3, depending on the diameter of the gas
hose used. After having tightened the hose connector(s), push
the gas hose 6 onto the hose connector and secure it with the
clamp 5 that is compliant with the applicable standard.
11.3.2Connection with a flexible steel hose
WARNING: The following instructions are valid for all types of installation, see fig. A, B, C in
chapter "11.1 Installing in kitchen units".
Only use standards-compliant continuous wall steel hoses no longer than 2 metres.
This type of installation can be used for both built-in and free-standing appliances.
Make the connection to the gas mains using a continuous wall flexible steel hose
whose specifications comply with the applicable standard.
Carefully screw the connector 3 to the appliance's gas connector 1 (1/2" thread ISO
228-1), placing the seal 2 between them.

11.4 Electrical connection

Make sure the voltage and the cross-section of the power supply line match the specifications indicated
on the identification plate positioned on the appliance. Do not remove this plate for any reason. A copy of
the plate is attached to the instructions.
The appliance must be connected to the power supply by a qualified technician.
Before performing any operations, switch off the power supply to the appliance.
The appliance must be connected to earth in compliance with electrical system safety standards.
Where the appliance is connected to the power grid via plug and socket, both of these must be of the
same type and connected to the power cable in accordance with current standards. The socket must be
accessible after the appliance has been built in. NEVER UNPLUG BY PULLING ON THE CABLE.
Should the earthing wire need replacing it must be longer than the conducting wires so that, if the plug is
torn off the power cable, it is the last to be detached.
62
Instructions for the installer
1
2
5
6
1
2
3
3
3
4