Table of Contents
Advertisement
AXIS Q3709-PVE Network Camera
Hardware Overview
2
Slot for removing Weather shield (bottom)
3
Weather shield (bottom)
Connectors and Buttons
For technical specifications, see page 56.
Network Connector
RJ45 with High Power over Ethernet (High PoE).
NOTICE
NO
NO
TICE
TICE
The product shall be connected using a shielded network cable (STP). All cables connecting the product to the network shall
be intended for their specific use. Make sure that the network devices are installed in accordance with the manufacturer's
instructions. For information about regulatory requirements, see Electromagnetic Compatibility (EMC) on page 2 .
Control Button
For location of the control button, see Hardware Overview on page 7 .
The control button is used for:
•
Resetting the product to factory default settings. See page 51.
•
Connecting to an AXIS Video Hosting System service. See page 45. To connect, press and hold the button for about 3
seconds until the Status LED flashes green.
•
Connecting to AXIS Internet Dynamic DNS Service. See page 45. To connect, press and hold the button for about 3 seconds.
Restart Button
Press the restart button to restart the product.
LED Indicators
Note
• The Status LED can be configured to flash while an event is active.
• The Status LED can be configured to flash for identifying the unit. Go to Setup > System Options > Maintenance .
Status LED
Unlit
Green
Amber
Amber/Red
Indication
Connection and normal operation.
Shows steady green for 10 seconds for normal operation after startup completed.
Flashes before startup if the temperature is below -20 °C and heating is required. The product
starts when it reaches operating temperature.
Steady during startup. Flashes during firmware upgrade.
Flashes amber/red if network connection is unavailable or lost.
8
Advertisement
Table of Contents
