Levelling The Cooker; Wall Fixing; Practical Storage Of Cooking Utensils; Setting Up The Appliance - Bosch Fornuis HGV74W221N Instruction Manual

Levelling the cooker

Always place the cooker directly on the floor.
Pull out the plinth drawer and lift it up and out.
1.
There are adjustable feet at the front and rear on the inside of
the plinth.
Use an Allen key to raise or lower the adjustable feet as
2.
necessary until the cooker is level (picture A).
Push the plinth drawer back in (picture B).
3.

Wall fixing

To prevent the cooker from tipping over, you must fix it to the
wall using the enclosed bracket. Please observe the installation
instructions for fixing the oven to the wall.

Practical storage of cooking utensils.

This is intended to be used to hang up cooking utensils (ladle,
tongs, etc.). It must be attached to the upper cover. You can
find detailed instructions in the installation instructions.
Caution!
Only suitable for hanging up stainless-steel cooking utensils
■
(e.g. ladle, tongs).
Hang the cooking utensils (e.g. ladle, tongs, etc.) only when
■
they are clean. You must rinse and dry dirty and wet cooking
utensils before hanging them up.
Carefully remove all hanging objects before operating the
■
hob.
Fully remove the cooking utensils before closing the upper
■
glass cover.
:
Risk of fire!
If flammable objects are hung up, they may ignite. Only suitable
for hanging up stainless-steel cooking utensils (e.g. ladle,
tongs). Objects made of flammable material (e.g. wood, plastic,
paper, cotton, etc.) must not be hung up.
:
Risk of scalding!
If the hotplates are in use, any cookware and cooking utensils
that are hung on the upper cover will become hot. Carefully
remove the cooking utensils before you operate the hotplates.
:
Risk of injury!
Hang up cooking utensils carefully and slowly. Otherwise, you
may break or scratch the glass cover.
Remove the cooking utensils carefully and slowly. Removing
the cooking utensils too quickly or jerkily may lead to damage
on the upper glass cover or to injuries.
A scratched glass cover may break and fragment.
Cleaning
The individual parts can be removed for cleaning. You can find
detailed instructions in the installation instructions.
Do not place the individual parts in the dishwasher.
Wipe with a damp cloth and some washing-up liquid. Dry with a
soft cloth.
Do not use any abrasive cleaning agents or sharp metal
objects.
8

Setting up the appliance

The appliance must be set up directly on the kitchen floor
■
and in line with the specified dimensions. The appliance must
not be set up on any other object.
The distance between the top edge of the oven and the
■
bottom edge of the extractor hood must meet the
requirements of the extractor hood manufacturer.
Ensure that the appliance is not moved again after set up.
■
The distance from the high output burner or wok burner to
the fronts of the adjacent units or the wall must be at least 50
mm.

Measures to be noted during transport

Secure all mobile parts in and on the appliance using an
adhesive tape that can be removed without leaving any traces.
Push all accessories (e.g. baking tray) into the corresponding
slots with cardboard at the edges, in order to avoid damaging
the appliance. Place cardboard or similar between the front and
rear side to prevent knocks against the inside of the glass door.
Secure the door and, if available, the top cover to the appliance
sides using adhesive tape.
Keep the original appliance packaging. Only transport the
appliance in the original packaging. Observe the transport
arrows on the packaging.
If the original packaging is no longer available
pack the appliance in protective packaging to guarantee
sufficient protection against any transport damage.
Transport the appliance in an upright position. Do not hold the
appliance by the door handle or the connections on the rear, as
these could be damaged. Do not place any heavy objects on
the appliance.