Table of Contents
Advertisement
Installation and connection
Electrical connection
The appliance must be connected to the mains by a licensed
expert. The regulations of your electricity supplier must be
observed.
Any damage arising from the appliance being connected
incorrectly will invalidate the guarantee.
For the installer
An all-pole isolating switch with a contact gap of at least
■
3 mm must be present in the installation circuit. This is not
necessary if the appliance is connected by a plug that is
accessible to the user.
Electrical safety: The cooker corresponds to safety class I
■
and may only be used in conjunction with a safety earth
terminal.
Your new cooker
Here you will learn about your new cooker. We will explain the
control panel, the hob and the individual operating controls.
General information
The design depends on the respective appliance model.
Explanations
1
Hob**
2
Control panel**
3
Cooling fan
4
Oven door**
5*
Plinth drawer**
* Optional (available for some appliances)
** Details may vary depending on the appliance model.
A type H 05 VV-F or equally rated lead must be used to
■
connect the appliance.
Levelling the cooker
Always place the cooker directly on the floor.
The cooker has height-adjustable feet. This allows you to raise
the plinth by about 15 mm. Please observe the special
installation instructions.
Wall fixing
To prevent the cooker from tipping over, you must fix it to the
wall at the chain and with the protection angle. Please observe
the installation instructions for fixing the oven to the wall.
You will find information on the cooking compartment and the
accessories.
Cooking area
Here is an overview of the control panel. The design depends
on the respective appliance model.
Explanations
1
Hotplate 17 cm or extended cooking zone 17x26
cm
2
Hotplate 14,5 cm
3
Hotplate 18 cm
4
Dual-circuit hotplate 21 and 12 cm
5
Residual heat indicator
Residual heat indicator
The hob has a residual heat indicator for each hotplate. It
shows which hotplates are still hot. Even if the hob is switched
off, the display remains lit until the hotplate has cooled down
sufficiently.
You can save energy by using the residual heat to keep a small
dish warm, for example.
7
Advertisement
Table of Contents
