Foxconn G31MX 2.0 Series User Manual page 23

front Panel Connector : fP1
This motherboard includes one connector for connecting the
front panel switch and LED Indicators.
Hard Disk leD Connector (HDD-leD)
Connect to the chassis front panel IDE indicator LED. It
indicates the active status of the hard disks. This 2-pin
connector is directional with +/- sign.
Reset Switch (ReSeT-SW)
Attach the connector to the Reset switch on the front
panel of the case; the system will restart when the switch
is pressed.
Power leD Connector (PWR-leD)
Connect to the power LED indicator on the front panel of
the chassis. The Power LED indicates the system's status.
When the system is in operation (S0 status), the LED is
on. When the system gets into sleep mode (S1) , the LED
is blinking; When the system is in S3/S4 sleep state or
power off mode (S5), the LED is off. This 2-pin connector
is directional with +/- sign.
Power Switch Connector (PWR-SW)
Connect to the power button on the front panel of the
chassis. Push this switch allows the system to be turned
on and off rather than using the power supply button.
Speaker Connector : SPeAKeR
The speaker connector is used to connect speaker of the
chassis.
USb Connectors : f_USb1/2
In addition to the four USB ports on the rear panel, this product
also provides two 10-pin USB connectors on its motherboard.
By connecting through USB cables with them, user can quickly
expand another four USB ports on the front panel.
Audio Connector : CD_IN
CD_IN is a Sony standard audio connector, it can be connected
to a CD/DVD-ROM drive through a CD/DVD audio cable.
HDD-LED
RESET-SW
SPKJ
EMPTY
NC
SPKJ
SPEAKER
CD_L GND CD_R
16
1 2
+ +
PWR-LED
-
-
PWR-SW
NC EMPTY
10
9
FP1
1
2
VCC VCC
D- D-
D+
D+
GND GND
NC
EMPTY
9 10
F_USB 1/2
CD_IN