Table of Contents
Advertisement
SATA Configuration
SATA Controller
The optional settings are: [Enabled]; [Disabled].
When set as [Enabled], the following items shall appear:
SATA Mode Selection
The default setting is: [AHCI].
SATA Interface Speed
The item is for user to set the maximum speed the SATA controller can support.
The optional settings are: [Gen1]; [Gen2]; [Gen3].
SATA Port1/mSATA
Port1
The optional settings are: [Enabled]; [Disabled].
Network Stack Configuration
Press [Enter] to go to 'Network Stack' screen to make further settings.
Network Stack
The optional settings are: [Enabled]; [Disabled].
When set as [Enabled], the following sub-items shall appear:
Ipv4 PXE Support
The optional settings are: [Disabled]; [Enabled].
Use this item to enable Ipv4 PXE Boot Support. When set as [Disabled], Ipv4 boot
optional will not be created.
Ipv6 PXE Support
The optional settings are: [Disabled]; [Enabled].
Use this item to enable Ipv6 PXE Boot Support. When set as [Disabled], Ipv6 boot
optional will not be created.
PXE boot wait time
Use this item to set wait time to press [ESC] key to abort the PXE boot.
Media Detect Count
Use this item to set number of times presence of media will be checked.
The optional settings range from [1] to [50].
36
Advertisement
Table of Contents
