Supply; Hoses And Cable Lengths; Water-Supply Hose - Panasonic NA-148VG4 Operating Instructions & Installation Instructions

Connecting Hoses and Power Supply
Follow the instructions in this section to prevent water leaks. If you are unsure, ask a service
agent to connect the hoses.

Hoses and cable lengths

Left side connections

Water-supply hose

Caution
- Do NOT connect the water-supply
hose to a combination tap.
- Do NOT twist, squash, modify, or
cut the hose.
- Optimum mains water pressure is 0.03 -
1.0 MPa. If the water pressure exceeds
this value, install a pressure reducing
valve.
- Water-flow from the tap should be more
than 5 L/min.
38 - Installation Instructions
NA-140_168_148VG4_WGB_En.indb
Downloaded from www.Manualslib.com
~ 105 cm
~ 130 cm
~ 100 cm
38
manuals search engine
Right side connections
~ 135 cm
~ 90 cm
~ 140 cm
Connecting the water-supply hose
1. Attach one end of the hose to
the water inlet on the back of the
appliance and tighten the joint by
hand.
2. Attach the other end of the hose to
the tap and tighten it the same way.
3/4"
min. 10 mm
Hose with water- Standard hose
supply valve
3. Open the tap slowly and make sure
that there are no leaks around the
joints.
The joints are subject to water pressure.
3/4"
min. 10 mm
2013/08/05 13:13:03