Advertisement
Available languages
Available languages
9
BIU405 BUILT-IN INSTRUCTIONS
N570-0086
N080-0215
N080-0215
N570-0086
N010-0281
W445-0031
N715-0083
N080-0155
This grill is designed for masonry, NON-COMBUSTIBLE enclosures only, and must be installed and serviced by a
qualified installer to local codes. Access must be provided in the enclosure for drip tray removal and cleaning.
1. Attach side mounting brackets to each side of the grill using #14 x 1/2" screws (N570-0086). The wings on
the rear trim should be under the side mounting brackets.
2. Lay the rear trim piece across the back of the opening. To keep it in place, a dab of silicone may be applied
to each wing of the rear trim.
3. Attach the supplied brackets flush with the front of the opening as per the dimensions in the above drawing
(fasteners not included).
4. Lower the unit in place ensuring the brackets installed in the previous step engage between the control
panel and the base bracket. Connect the flex line to the fitting at the end of the manifold.
5. The entire installation must be leak tested before operating the unit.
www.napoleongrills.com
Advertisement
