Advertisement
Available languages
Available languages
8
BIPT750 BUILT-IN INSTRUCTIONS
N080-0213
N570-0086
N570-0086
N080-0213
W445-0031
N010-0281
N715-0082
N010-0570
This grill is designed for masonry, NON-COMBUSTIBLE enclosures only, and must be installed and serviced by a
qualified installer to local codes.
1. Attach side mounting brackets to each side of the grill using #14 x 1/2" screws (N570-0026).
2. Lay the rear trim piece across the back of the opening. To keep it in place, a dab of silicone may be applied
to each wing of the rear trim.
3. Lower the unit in place, the wings on the rear trim should be under the side mounting brackets. Connect the
flex supply line to the fitting at the end of the manifold.
4.The entire installation must be leak tested before operating the unit.
www.napoleongrills.com
Advertisement
