Lighting Instructions - Napoleon LA200SB Manual

6

Lighting Instructions

EN
WARNING!
WARNING!
valve.
2. Push and turn any main burner knob slowly to the 'hi' position. This action will ignite the
pilot flame which will in turn light the selected burner. If the pilot lights, continue to push
3. If the pilot does not ignite, then immediately turn the control knob back to the 'off position
4. If the pilot and burner will not ignite within 5 seconds, turn the control knob to the 'off'
position and wait 5 minutes for any excess gas to dissipate. Either repeat steps 2 and 3 or light
5. If lighting the unit with a match, clip the match into the supplied lighting rod. Hold the lit
match down through the grill and sear plate while turning the corresponding burner valve to
WARNING!
turned off prior to turning the cylinder on, only small flames and low heat will be achievable.
WARNING!
www.napoleongrills.com
Left
Burner
Open lid.
Ensure all burner controls are in the off position. Turn on the gas supply
Main Tube Burner Lighting
1. Open grill lid.
down on the control knob until the burner lights and then release.
and repeat step 2 several times.
with a match.
The propane cylinder is equipped with an excess flow device. Unless all burners are
Do not use the rear burner (rotisserie burner) with the main burners operating.
Right
Burner
Off Position
high.