Operation
EMU36531
Checks after engine warm up
EMU36541
Shifting
While the boat is tightly moored, and without
applying throttle, confirm that the engine
shifts smoothly into forward and reverse, and
back to neutral.
EMU41820
Stop switches
Perform the following procedure to check
that the main switch and engine shut-off
switch operate properly.
Check that the engine stops when the
●
main switch is turned to the "
sition, or press the Start/Stop button.
Check that the engine stops when the clip
●
is pulled from the engine shut-off switch.
Check that the engine cannot be started
●
with the clip removed from the engine
shut-off switch.
EMU35880
Selecting outboard motor
(triple engine)
After all engines have started, set all control
levers to Neutral. Push the engine selector
switch repeatedly to change the digital elec-
tronic control-active indicator and select the
desired engine.
65
" (off) po-
1. Port side control lever
2. Starboard side control lever
3. Port side engine
4. Center engine
5. Starboard side engine
1.
First, three engines can be operated.
TIP:
When all engines have started, the center
engine will run at the average speed of port
side and starboard side engines' speeds.
Operate the port side engine using the port
●
1
P
C
S
3
4
5
2
ZMU05998
ZMU05999