Table of Contents
Advertisement
End of the Vapor Clean cycle
1. Open the door and wipe away the less
stubborn dirt with a microfibre cloth.
2. Use an anti-scratch sponge with brass
filaments on tougher encrustations.
3. In case of grease residues use specific
oven cleaning products.
4. Remove the water left inside the oven.
For improved hygiene and to avoid food
being affected by any unpleasant odours,
we recommend that the oven is dried using
a fan assisted function at 160°C for
approximately 10 minutes.
We recommend wearing rubber
gloves for these operations.
For easier manual cleaning of the
parts difficult to reach, we
recommend removing the door.
What to do if...
The display is completely off:
• Check the mains power supply.
• Check whether an omnipolar switch
upstream of the appliance supply line is
in the "ON" position.
The appliance does not heat up:
• Check whether it has been set in "demo"
mode (for further details see "Demo
mode (for showrooms only)").
Cleaning and maintenance
The controls do not respond:
• Check whether it has been set in
"controls lock" mode (for further details
see "Controls lock").
The cooking times are longer than those
indicated in the table:
• Check whether it has been set in "Eco-
logic" mode (for further details see "Eco-
Logic").
If the door is opened during a fan assisted
function, the fan stops:
• This is not a fault. It is a normal operation
of the appliance, useful when cooking
foods in order to avoid excessive heat
escaping. When the door is closed, the
oven will return to normal operation.
If the problem has not been
resolved or in the case of other
types of fault, contact your local
technical support centre.
If other ERRx error messages are
indicated:
Note down the error message,
function and set temperature and
contact your local technical
support centre.
117
Advertisement
Table of Contents
