Before Using For The First Time; Water Connection; Electrical Connection - Thermador T24IF900SP Use & Care Manual

Before using for the first time

Remove leaflets, adhesive tape and protective
1.
foil.
Clean the appliance.
2.
~ "Cleaning" on page 15

Water connection

9
CAUTION!
Installation and connection of the appliance
■
must be carried out by qualified technicians
according to the installation instructions
supplied.
To avoid damage to the appliance and to
■
ensure its proper functioning, it should only be
connected to a drinking water system.
To avoid water damage, a shut-off valve must
■
be installed.
Water pressure of drinking water system
9
CAUTION!
To avoid damage to the appliance, a pressure
relief valve must be installed between the
drinking water connection and the tubing,
should the water pressure exceed the
maximum value.
If the water pressure is too low, this will impair
Note:
the relevant functions of the appliance.
Min. 0.2 Mpa (2 bar)
■
Max. 0.8 Mpa (8 bar)
■
Installation and connection en-us

Electrical connection

9
CAUTION!
Do not connect the appliance to electronic
energy saver plugs.
You can connect the appliance to mains-
Note:
controlled and sine-controlled inverters.
Mains-controlled inverters are used for photovoltaic
systems which are connected directly to the national
grid. Sine- controlled inverters must be used for
isolated applications. Isolated applications, e.g. on
ships or in mountain lodges, are not directly
connected to the national grid.
After installing the appliance, wait at least 1 hour
1.
before connecting it to prevent damaging the
compressor.
Connect the appliance via a correctly installed
2.
outlet.
9
WARNING
RISK OF ELECTRIC SHOCK!
The appliance must be properly grounded.
Never cut through or remove the third
(ground) conductor of the power cord.
Never use adapters.
Never use extension leads.
Requirements for outlets
Outlet with 115 V
protective 60 Hz
conductor
Fuse 10 A ... 16 A
Maximum simultaneous load
Freezer 18" 3.5 A
Freezer 24" 4.0 A
Freezer 30" 4.5 A
Connect the appliance to a socket near the
3.
appliance.
The socket must be freely accessible even after
the appliance has been installed.
7