Installation Instructions; Unpack The Range - Jenn-Air Pro-Style JGRP536WP Installation Instructions Manual

WARNING
Excessive Weight Hazard
Use two or more people to move and install range.
Failure to do so can result in back or other injury.
1. Remove shipping materials, tape, and film from range.
Keep shipping pallet under range. Remove oven racks,
grates, and parts package from inside oven.
2. Remove kick plate.
Your range will either have the kick plate already installed
(follow Option 1) or packaged on top of the unit (follow
Option 2).
Option 1
a. Remove foam between door and kick plate.
b. Remove screws from kick plate.
A
A. Kick plate
B. Remove these screws.
c. Lift up on kick plate to release plate from shoulder
screws.
d. Lay kick plate to the side to avoid scratching the
stainless steel.
Option 2
a. Remove kick plate from top of range and grate pack.
In packaging
A. Kick plate
10

INSTALLATION INSTRUCTIONS

Unpack the Range

B
A
Packaging removed
A. Kick plate
b. Lay kick plate to the side to avoid scratching the
stainless steel.
c. Remove screws from range.
A. Remove these screws.
3. For 48" (121.9 cm) models only, rotate center support
counterclockwise off the pallet until it stops.
NOTE: This support is used only for shipping and is not
needed for installation.
4. Lay a piece of cardboard from side packaging on the floor
behind range. Using two or more people, firmly grasp
each side of range. Lift range up about 3" (8.0 cm) and
move it back until range is off shipping pallet. Set range on
cardboard to avoid damaging floor.
A