Horn Switch Check; Engine Shut-Off Cord (Lanyard) Check; Post-Launch Checks; Engine Shut-Off Switch Check - Yamaha AR195 Owner's/Operator's Manual

SX195/SX190
2
1 Bow light
2 Anchor light
(3) Push the bottom of the navigation and
anchor lights switch and check that only
the anchor light comes on.
(4) Put the navigation and anchor lights
switch in the middle position and check
that the bow light and anchor light are off.
(5) Remove the anchor light.

Horn switch check

Push the horn switch and check that the horn
sounds.
CTSY
NAV/ANC
LIGHTS
1 Horn switch

Engine shut-off cord (lanyard) check

Make sure that the engine shut-off cord (lan-
yard) is not damaged. If the cord is damaged,
replace it. WARNING! Never try to repair
the engine shut-off cord (lanyard) or tie it
1
1
HORN
Pre-operation checks
together. The engine shut-off cord (lan-
yard) may not pull free when the operator
falls off, allowing the boat to continue to
run and cause an accident.

Post-launch checks

Perform the post-launch checks in the pre-op-
eration checklist while the boat is in the water
and the engine is running.

Engine shut-off switch check

Check the engine shut-off switch for proper
operation.
(1) Start the engine. (See page 93 for infor-
mation on starting the engine.)
(2) Pull the engine shut-off cord (lanyard) to
remove the clip from the engine shut-off
switch to make sure that the engine stops
immediately.
(3) Make sure that the engine cannot be
started with the clip removed from the en-
gine shut-off switch.
91