Samsung RF62U Series User Manual page 9

Required Tools (Not provided)
Phillips Head Flat Head Driver(-)
Driver(+)
Hex Wrench Hex wrench
(Ø5mm) (5/32 inch)
(for Mid hinge) (for Mid hinge
Disassembling the fridge door
Be careful not to drop and scratch the fridge door while removing the fridge door!
WARNING
1. Remove the 3 screws
holding down the top table
and remove it.
4. Remove the screw that
holds the ground wire with
a philips screwdriver(+).
DA68-01868T.indb 섹션2:09 DA68-01868T.indb 섹션2:09
Socket Wrench
(10mm) (for bolts)
shaft)
Top Table Top Table
2. Disconnect electric wire on
the top of the refrigerator.
5. Separate the hinge from
the electric wire and
ground wire as shown
above.
REMOVING THE
REFRIGERATOR DOORS
Some installations require door/drawer removal to
transport the Refrigerator to its fi nal location.
Do not remove the door/drawer if it is not needed.
Before removing the door/drawer make sure you
read following items.
Disconnect power to the Refrigerator before
removing the door or drawer.
CAUTION
• Be careful not to drop, damage or scratch
the door/drawer while removing them.
• Be careful not to get injured while removing the
door/drawer.
• Reattach the door/drawer properly to avoid:
- Moisture from air leakage.
- Uneven door alignment.
- Wasting energy due to improper door seal.
3. Remove the 3 hex bolts
that hold the hinge on the
top of the refrigerator with
the 10mm socket wrench.
6. Lift the door straight up to
remove. Be careful not to
drop and scratch the doors
while removing them.
Socket wrench Socket wrench
setting up _09 setting up _09
2011.7.4 9:22:4 PM 2011.7.4 9:22:4 PM