Whirlpool WRS555SIHZ06 Owner's Manual page 4

3. Replace the burned-out light bulb, as explained in the
following sections.
4. Reinstall the light shield, as explained in the following
sections.
5. Plug in refrigerator or reconnect power.
Refrigerator Compartment – Upper Lights
Light Shield Removal:
Slide the light shield toward the rear of the refrigerator and remove
it from the light housing.
Replacement Bulb:
� If the burned-out light is a full-size LED bulb, replace it with a
2.0 W LED bulb.
� If the burned-out light is an incandescent bulb, replace it with
an incandescent appliance bulb of the same size, shape, and
wattage (40 W maximum).
Light Shield Reinstallation:
Align the light shield in the grooves at the bottom edge of the light
housing; then slide it forward until it snaps into place.
Refrigerator Compartment – Lower Lights
Light Shield Removal:
Slide the light shield to the right to remove the left end from the
wall slots; then pull the right end out of its wall slots.
Replacement Bulb:
� If the burned-out light is a full-size LED bulb, replace it with a
3.6 W LED bulb.
� If the burned-out light is an incandescent bulb, replace it with
an incandescent appliance bulb of the same size, shape, and
wattage (40 W maximum).
4
Light Shield Reinstallation:
Place the right end of the light shield into the wall slots; then snap
the left end into its wall slots.
Freezer Compartment – Upper Light
Light Shield Removal:
Gently squeeze the front and the bottom-rear edge of the light
shield to release the tabs from the wall slots; then pull the light
shield forward.
Replacement Bulb:
� If the burned-out light is a full-size LED bulb, replace it with a
3.6 W LED bulb.
� If the burned-out light is an incandescent bulb, replace it with
an incandescent appliance bulb of the same size, shape, and
wattage (40 W maximum).
Light Shield Reinstallation:
Align the light shield in its proper position, and snap the tabs into
the wall slots.
Freezer Compartment – Lower Light
Light Shield Removal:
Slide the light shield to the left to remove the right end from the
wall slots; then pull the left end out of its wall slots.
Replacement Bulb:
� If the burned-out light is a full-size LED bulb, replace it with a
3.6 W LED bulb.
� If the burned-out light is an incandescent bulb, replace it with
an incandescent appliance bulb of the same size, shape, and
wattage (40 W maximum).