Remove Doors And Hinges - Whirlpool WRS555SIHZ06 Owner's Manual

Remove Doors and Hinges

WARNING
Electrical Shock Hazard
Disconnect power before removing doors.
Failure to do so could result in death or electrical shock.
1. Unplug refrigerator or disconnect power.
2. Open both doors to 90°. Remove the base grille by removing
the two screws, then pulling out on the outside corners as
shown below.
NOTE: The doors must only be opened to 90°. If they are
opened all the way, the base grille will not come off.
24
3. Disconnect the water tubing, located behind the base grille on
the freezer door side. The dispenser tubing runs through the
door hinge and must be disconnected in order to remove the
door.
NOTE: On models with the ice storage bin on the door, there
are two water tubing connections, as shown. On models with
the ice storage bin inside the freezer, there is only one water
tubing connection.
� Water Tubing Connection Style 1: Press the colored
outer ring against the face of the fitting and gently pull the
dispenser tubing free as shown below.
A. Face of Fitting
NOTE: Keep the water tubing connector attached to the
tube that runs underneath the freezer. The door cannot be
removed if the connector is still attached to the tube that
runs through the door hinge.
� Water Tubing Connection Style 2: Firmly pull on the
clasp to release the tube, then pull the water tubing free as
show below.
NOTE: Keep the clasp attached to the tube that runs
underneath the freezer.