Gas Supply Connection; Electrical Connection; Levelling The Cooker - Coolzone CZ55513 Installation And Operating Instructions Manual

Gas supply connection

PLEASE NOTE: Connection of the gas supply, adjustment, cleaning and tap servicing should ONLY
be carried out by a CORGI registered gas fitter or qualified service engineer, in accordance with the
latest regulations.
There are two installation options:
Connection to natural gas supply
The cooker comes ready for connection to a piped supply of natural gas, and should only be connected by
a CORGI registered gas fitter or qualified service personnel, in accordance with the latest regulations.
Before connecting the cooker to the gas supply system, ensure that the appliance is compatible with the
local distribution conditions (nature of the gas and gas pressure). In the event of incompatibility, consult a
CORGI registered installer to make the necessary adaptations or adjustments.
Connection to an LPG cylinder
Alternatively, the hob can be connected to an LPG cylinder. In this case, LPG injector jets (not supplied -
contact the helpline) should be fitted to the burners by the qualified service engineer. Use a rubber hose
with a safety certificate to connect the applicance to the LPG cylinder.
Every time the hob has been connected to an LPG cylinder, check the cylinder valve for soundness and the
connection of the regulator to the cylinder and also its operation.
WARNING: Under no circumstances should the gas tightness be checked by means of a naked
flame (e.g with a match or candle) as there is a danger of explosion.
WARNING: Before starting any adjustments or changing the injectors, disconnect the appliance
from gas and mains electricity supply.

Electrical connection

Once the gas supply has been connected, plug the cooker into the 3-pin socket, and switch the socket ON.

Levelling the cooker

The cooker is equipped with adjustable feet designed for levelling the cooker
and for adjusting the upper edge of the cooker to furniture level. (Figure 3)
1. Move the cooker into its final position.
2. If the upper edge of the cooker is not at the same height as adjoining units,
use the adjustable feet to raise or lower the unit to the required height.
3. If the cooker is not level or is unstable due to an uneven floor surface, use
the adjustable feet to adjust each corner until the cooker is level.
6
Figure 3 - Adjustable foot