Changing The Oven And Grill Lamps; Mains Lead Replacement; Plug Replacement - Coolzone CZ55513 Installation And Operating Instructions Manual

60cm double cavity gas cooker
Table of Contents

Advertisement

Changing the grill and oven lamps
Wait for the cooker and lamp to cool.
Unscrew and remove the diffuser.
Unscrew the lamp from the lampholder.
Replace lamp and diffuser (Figure 17).
The replacement lamp must be of the same type, voltage and wattage (15W SES 300°C).

Mains lead replacement

Do not attempt to repair or replace the mains connecting cable yourself, consult a qualified
electrician.

Plug replacement

This product is supplied with a fitted plug which contains a
3A fuse. If you are simply replacing the fuse, you must use
a 3A fuse which has been approved by ASTA to BS1362.
If the plug does not fit the socket or becomes damaged, a
new plug must be fitted. Replace the original plug with the
correct plug for your socket. If this is a 3-pin (square pin)
13A (BS1363) plug, you must make sure that it is fitted
with an ASTA approved 3A fuse. If another type of plug is
used, it must be protected by a 5A fuse, either in the plug
or at the distribution board.
1. Remove the existing fitted plug.
2. The wires in the mains lead supplied with this appliance are coloured in accordance with the following
code:
GREEN/YELLOW = EARTH (E)
This product must be earthed
As the colours of the wires in the mains lead may not correspond with the colour markings identifying the
terminals in your new plug, proceed as follows.
The wire which is coloured GREEN or GREEN/YELLOW must be connected to the terminal which is
marked with the letter E or E symbol or coloured GREEN or GREEN/YELLOW.
The wire which is coloured BLUE must be connected to the terminal in the plug which is marked with the
letter N or coloured BLACK or BLUE.
The wire which is coloured BROWN must be connected to the terminal which is marked with the letter L or
coloured RED or BROWN.
3. Ensure that the connections are tight and that no loose strands are left out of the terminals.
IF IN ANY DOUBT CONSULT A QUALIFIED ELECTRICIAN.
DIFFUSER
LAMP
Figure 17 - changing the lamp
BLUE = NEUTRAL (N)
LAMPHOLDER
GREEN/
YELLOW
(EARTH)
BLUE
(NEUTRAL)
Figure 18 - Plug wiring
BROWN = LIVE (L)
13
FUSE
BROWN
(LIVE)
CABLE
CLAMP

Advertisement

Table of Contents
loading

Table of Contents