Electricity Supply; Safety Chain Anchors - Coolzone CZ55513 Installation And Operating Instructions Manual

Electricity supply

A switched 3-pin plug socket with an earth contact, if one does not already exist, should be installed on the
wall behind the cooker (Figure 1).
WARNING: This appliance must be earthed. Connecting the cooker to a socket without an earth
contact may result in an electric shock
This installation must be carried out in accordance with current I.E.E wiring regulations and Building
Regulations (Part P).
The 3-pin socket should be close enough so that the appliance can be easily plugged in without stretching
the mains supply cable.
The mains supply cable must be routed away from hot surfaces.
The mains voltage must correspond exactly to that which is specified on the data plate.
If in any doubt consult a qualified electrician.

Safety chain anchors

In order to eliminate the risk of the cooker falling forward, two chains have been installed at the rear of the
cooker. Before use, these will need to be fastened securely to the wall behind the appliance with the
anchor brackets supplied. (Figure 2):
1. Decide on a suitable wall location for fitting the anchor brackets directly behind each cooker safety
chain (Figure 2).
2. Hold the chain anchor up to the wall where it will be required, and mark the fixing holes. (Figure 2).
3. Drill the fixing holes and fix the chain anchors to the wall using the screws provided and suitable wall
plugs for the type of wall being fixed to.
4. Leave the chains unattached until the installation process has been completed.
ANCHOR
BRACKET
SCREWS
WALL
PLUGS
Figure 2 - fixing an anchor bracket
5
FIXING
HOLES