Thermostat Installation - USSC Ashley AP5660L Installation And Operating Manual

Optional thermostats are available for use with your pellet stove. A thermostat can help you maintain a constant room
temperature. The thermostat option will require the installation of a millivolt type thermostat.
NOTE: Your thermostat should be installed by an authorized dealer or service person.
Installation of Remote Thermostat:
•
Disconnect Pellet Stove Room Heater unit from power supply.
•
Open right side panel to gain access to rear of control panel.
•
Strip insulation from thermostat wires and connect to the screw terminal on the rear of the control panel (see Figure 4).
If you have installed a remote thermostat for your pellet stove and wish to have the heater controlled by that thermostat,
depress the MODE button to engage T-STAT mode. The thermostat will control the heat output of the heater alternating
between the lowest heat level and the highest heat level that you have pre-selected.
The T-STAT mode provides the most even heat output, for better comfort, and to extend the life of the pellet fuel ignition
system. Additionally, the constant fl ame serves as a warning for people and pets to keep away from the heater while it is
in operation.

THERMOSTAT INSTALLATION

Connection Terminal for External Th ermostat
Left : GND
Middle: Th ermostat
Right: 5V power source
Figure 4
9