Honda TRX400X 2009 Owner's Manual page 108

Engine Oil & Filter
4. Reinstall the oil filter cover, making sure the bolts are tightened to the
specified torque:
7 lbf·ft (10 N·m , 1.0 kgf·m)
5. Pour the drained oil into a suitable container and dispose of it in an
approved manner (page
Improper disposal of drained f luids is harmf ul to the environment.
Add Engine Oil:
1. After the oil has drained, make sure the sealing washers on the drain
bolts are in good condition. If necessary, replace the sealing washers.
2. Reinstall the drain bolts and tighten to the specified torque:
Engine oil drain bolt (oil tank):
14 lbf·ft (20 N·m , 2.0 kgf·m)
Engine oil drain bolt (crankcase):
18 lbf·ft (25 N·m , 2.5 kgf·m)
3. Fill the oil tank with the recommended grade oil approximately:
1.8 US qt (1.7 )
4. Reinstall the oil filler cap/dipstick.
5. Reinstall the engine guard.
6. Start the engine and let it idle for 3 5 minutes.
7. Stop the engine and after 2 3 minutes, check the oil level. Make
sure the oil is between the UPPER and LOWER level marks on the oil
filler cap/dipstick. If necessary, add more oil but do not overfill.
8. Reinstall the oil filler cap/dipstick.
9. Check for oil leaks.
If a torque wrench is not used for installation, see your Honda dealer as
soon as possible to verify proper assembly.
Servicing Your Honda
100
168 ).
−
−