Honda TRX400X 2009 Owner's Manual page 107

Install a New Engine Oil Filter:
1. Remove the oil filter cover ( ) by removing the bolts ( ). Let the
remaining oil drain out. Discard the oil filter ( ) in an approved
manner (page
2. Check that the oil filter cover O-ring ( ) is in good condition and
then install a new oil filter. Use only the Honda Genuine oil filter or a
filter of equivalent quality specified for your model. Using the wrong
Honda filter or a non-Honda filter which is not of equivalent quality
may cause engine damage.
3. Reposition the spring ( ) to the engine crankcase and install a new oil
filter with the rubber seal ( ) facing out, away from the engine. You
will see the ''OUTSIDE (TOWARDS FILTER COVER)'' mark ( )
on the filter body, near the seal.
Improper installation of the oil f ilter can cause serious engine damage.
RIGHT SIDE
(1) oil filter cover
(2) bolts
(3) oil filter
(4) O-ring
1
168 ).
5
6
(3)
Engine Oil & Filter
4
(7)
(5)
(6)
(5) spring
(6) rubber seal
(7) OUTSIDE mark
Servicing Your Honda
2
3
(4)
(1)
(2)
7
(cont'd)
99