Replacing An Existing Unit - GE Zoneline AZ65 Owner's Manual

Installation Instructions

REPLACING AN EXISTING UNIT

Use the correct wall case
is designed to be installed in a GE
minimizes condensation from forming on the room side
of the case.
NOTE:
flanges for installation in wall cases other than GE
the installer should use an awl or other sharp tool to
puncture the insulation in the appropriate holes before
installing the attachment screws.
Use the correct outdoor grille
You should use the outdoor grilles shown on the
•
efficiency will be reduced and the unit may fail to
operate properly or fail prematurely. A deflector
away from the air intake to allow the unit to function
properly. The grille must have a 65% minimum
free area (as calculated by ASHRAE). See the
Architects and Engineers Data Manual for more
detailed information.
• Any vertical deflectors in a non GE Appliances
condenser air recirculation that can cause the unit
failure.
Use the correct power cord
installations.
Replacing a ducted unit
Check the "Essential
New ducted installation:
important information.
using a duct adapter kit, the kit must be installed before
instructions are packed with the kit.
Duct kits available:
Existing ducted installation:
different components. Request this information from
your sales representative. Duct seals on existing
unit need to be removed and added to the new
unit.
• Replacing 230/208 volt units:
• Replacing 265 volt units:
When using a duct kit, you must always turn Mode
7 to ON "
Mounting
plate
"
Duct Mode
Shown ON
Duct
Case
49-7773