Yamaha TT-R50EA Owner's Manual page 67

3. Unhook the battery band, and then
pull the battery out of the battery
compartment.
1. Battery
2. Battery band
3. Battery coupler
4. Disconnect the battery coupler.
To install the battery
1. Connect the battery coupler.
2. Place the battery in the original po-
sition, and then hook the battery
band onto the holder.
3. Install the battery cover by install-
ing the bolts.
4. Install the seat.
PERIODIC MAINTENANCE AND ADJUSTMENT
To charge the battery
Have a Yamaha dealer charge the bat-
tery as soon as possible if it seems to
have discharged. Keep in mind that the
battery tends to discharge more quickly
if the vehicle is equipped with optional
electrical accessories.
NOTICE
To charge a VRLA (Valve Regulated
Lead Acid) battery, a special (con-
stant-voltage) battery charger is re-
quired. Using a conventional battery
charger will damage the battery.
To store the battery
1. If the vehicle will not be used for
more than one month, remove the
battery, fully charge it, and then
place it in a cool, dry place.
NOTICE: When removing the
battery, be sure the key is
turned to "OFF" before discon-
necting the coupler.
2. If the battery will be stored for more
than two months, check it at least
once a month and fully charge it if
necessary.
7-24
3. Fully charge the battery before in-
stallation. NOTICE: When install-
ing the battery, be sure the key
is turned to "OFF" before con-
necting the coupler.
NOTICE
ECA16521 Always keep the battery charged.
Storing a discharged battery can
cause permanent battery damage.
[ECA16322]
[ECA16930]
ECA16530
7