The Cause And Solution Of The Malfunction - Samsung ML-2851ND/SEE Service Manual

4.2.4 The cause and solution of the malfunction

1) Fuser Error
Description: All LEDs blinking.
1. Check whether a thermostat,
AC wire, and heat lamp are
thermistor is open or not.
3. Heat lamp ON/OFF test
due to a gear of a fuser is melted.
Service Manual
Alignment & Troubleshooting
open or not.
2. Check whether a
4. It could not operate
Replace the fuser if a thermostat
is open.
Replace the fuser if a thermistor
sensor is located deep inside of
a sponge.
Check whether the overheat
mode circuit operates normally
or not.
Replace the fuser.
4-46
Samsung Electronics