Table of Contents
Advertisement
3.
Use the Mylar tab built into the hard drive bracket to lift and remove the hard drive (3) from
the computer.
4.
If it is necessary to replace the hard drive connector cable or hard drive bracket:
a.
Remove the four Phillips PM3.0×4.0 screws (1) that secure the hard drive bracket to the
hard drive.
b.
Remove the hard drive bracket (2) from the hard drive.
c.
Disconnect the hard drive connector cable (3) from the hard drive.
Reverse this procedure to reassemble and install the hard drive.
Component replacement procedures
55
- Quick Links:
- Product Description
Hide quick links:
Advertisement
Table of Contents
