HP Pavilion DV6-6090 Maintenance And Service Manual page 103

Before removing the display assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
●
Optical drive (see
●
Hard drive (see
●
WLAN module (see
●
Keyboard (see
●
Top cover (see
●
System board (see
Remove the display assembly:
1. Release the wireless antenna cables from the clips (1) and the opening in the base enclosure.
CAUTION: Support the display assembly when removing the following screws. Failure to
support the display assembly can result in damage to the display assembly and other
computer components.
2. Remove the six Phillips PM2.5×5.0 screws (2) that secure the display assembly to the computer.
NOTE: The left-most screw on the left hinge secures a display panel cable ground loop (3).
3. Remove the display assembly (4).
Battery on page 50), and then remove the following components:
Optical drive on page
Hard drive on page 54)
WLAN module on page
Keyboard on page 61)
Top cover on page 65)
System board on page
51)
58)
78)
Component replacement procedures
95