HP Pavilion DV2-1001 Maintenance And Service Manual page 49

3. Lift the right side of the hard drive bay cover (2), swing it up and to the left, and remove the
cover (3). The hard drive bay cover is included in the Access doors, spare part number
517748-001.
4. Remove the three Phillips PM2.5x4.0 screws (1), and the one Phillips PM2.5x7.0 screw (2) that
secure the hard drive to the computer.
WARNING! Be sure to replace the 7.0-mm screw in the correct location as indicated below. If it
is accidentally screwed into one of the 4.0-mm screw locations, it imay damage the computer.
5. Use the Mylar tab to slide the hard drive to the left to disconnect it from the system board (3), and
then lift the hard drive up on the right and remove it from the hard drive bay (4).
6. If it is necessary to replace the hard drive bracket or any of the hard drive bracket components,
remove the two Phillips PM3.0x4.0 screws (1) from each side of the hard drive.
Component replacement procedures 41