Branch Table - Scytek electronic 2100RS Series Product Manual

Branch Feature
1. Ignition Door Locking
2. Ignition Door Unlocking
3. Door Unlock Pulse
4. Door Lock Pulse Length
5. Aux 2 Activate on Lock
6. Aux 1 Mode
7. Aux 2 Mode
8. Unlock with Aux 1
9. Start in Valet Mode
10. Lock after Start
11. Lock after Shutdown
12. Engine Run Time
13. Automatic Start Mode
14. Engine Sense Mode
15. Remote Start Program
16. Ignition 2 Output Program
17. Horn Honk Output
18. Turbo Mode
19. Extended Parking Lights
20 Horn Chirp Mode
4. Door Lock Pulse Length. Selects between a 1-second and a 3-second output for door locking and
unlocking. Program to 3 seconds for vehicles equipped with vacuum door locking systems.
5. Aux 2 Auto Activate with Arm. When selected, the Auxiliary 2 output will activate when the system
is armed. This feature can be used to roll-up windows, close sunroofs, activate accessories, etc.
6. Auxiliary 1 Mode. Selects from momentary, 10 second timed, or latched operation for Auxiliary 1.
Momentary operation provides an output for as long as the transmitter button is pressed.
Timed operation provides an output that turns on for 10 seconds each time the transmitter button is
pressed. If the button is pressed again during the 30 seconds, the output will turn off.
Latched operation provides an output that turns on when the transmitter button is pressed and remains
on until the transmitter button is pressed again.
Note: With the optional ScyNet network interface and Wizard software, any auxiliary function can be
programmed to output for 1 second up to 255 seconds.
7. Auxiliary 2 Mode. Selects from Momentary, Timed, or Latched operation for Auxiliary 2.
8. Unlock with Auxiliary 1. When selected, activating the Auxiliary 1 output (usually used to open the
trunk) will unlcok the vehicle doors.
9. Start in Valet Mode. Selects whether or not the vehicle can remote start while in the valet mode.
10. Lock After Start. When selected, the doors will automatically lock after remote starting.
11. Lock After Shutdown. When selected, the doors will automatically lock after remote shutdown.
12. Engine Run Time. Selects between 15 or 25 minutes for the remote start run cycle.
Button 1 (default)
On
Unlock All
Single
1 second
Off
Pulsed
Pulsed
Disabled
Disable
On
On
15 minutes
2 hours
Tachless
RPM Learn
Ignition 2 Output
Horn Output
Disabled
On
Normal
Button 2
Off
Unlock Driver Only
Double
3 seconds
On
Timed
Timed
Enabled
Enabled
Off
Off
25 minutes
1 hour
Tach Monitor
Gas Engine
Accessory 2 Output
Ignition 3 Output
Enabled
Off
Extended
Galaxy 2100RS - Page 17
Button 3
Off
Latched
Latched
Diesel Engine
Starter 2 Output