Table of Contents
Advertisement
Service cover
Description
Service cover
Before removing the service cover, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
Remove the service cover:
1.
Press in and slide latch (1) and release the right side of the service cover until the service cover
tabs disconnect from the computer.
2.
Lift up and remove the cover(2).
NOTE:
Reverse this procedure to insert the service cover.
Hard drive
NOTE:
36
Chapter 4 Removal and replacement procedures
Battery on page
Small tabs hold the cover in place. Firmly pull up on the cover to release the tabs.
Each hard drive spare part kit includes a cable adapter, bracket, and four rubber isolators.
34).
Spare part number
607768-001
Advertisement
Table of Contents
