HP Mini 1000 Maintenance And Service Manual page 56

2. Disconnect the following cables from the system board:
(1) Speaker cables
(2) Microphone cable
(3) Fan cable
(4) Power cable
(5) Display panel cable
NOTE:
devices on page
3. Remove the two Phillips PM1.6×2.5 screws (1) that secure the actuators for the power switch and
wireless on/off switch to the system board, and then remove the actuators (2).
NOTE:
48 Chapter 4 Removal and replacement procedures
The USB board pass-through cable was disconnected earlier (see
37).
The actuators are included in the Bracket Kit, spare part number 507318-001.
Mass storage