Using The Light Off Function; Using The Auto Clean Function - LG JW-Q12WUZA Owner's Manual

Wi-Fi (Optional)
5
Enables connection of the air conditioner to
the home Wi-Fi.
• Wi-Fi Pairing : Mode + Fan Speed
• Wi-Fi Off : Power + Fan Speed
Clean Filter
6
The Clean Filter LED lights up to notify you
that the filter needs to be cleaned. After
cleaning the filter, press Temp
together on the control panel to turn off the
Clean Filter light.
NOTE
• The filter reset must be done using the
control panel, not the remote control.
• This feature is a reminder to clean the
air filter for more efficient operation. The
LED light turns on after 250 hours of
operation.
Fan Speed
7
Press to set the Fan Speed to Low (F1),
Medium (F2) or High (F3).
Temperature Control
8
The thermostat monitors room
temperature to maintain the desired
temperature. The thermostat can be set
between 16 °C–30 °C (60 °F–86 °F).
Press or
decrease temperature setting.
Energy Saver
9
In this mode the compressor and fan
turn off when the set temperature is
achieved. Approximately every 3 minutes
the fan turns on to allow the unit sensor
to accurately determine if more cooling is
needed.
NOTE
• This function is available with Cooling
Mode.
Clear
10
Cancel Sleep and Timer settings. Also set
the Diagnosis if held for 5 seconds.
14
and
arrows to increase or
NOTE
• Auto Restart : If the air conditioner turns
off due to a power outage, it will restart
automatically once the power is restored, with
the same settings as were set before the unit
turned off.
• Energy Saver : The unit defaults to the Energy
Saver mode each time the unit is switched on
except in Fan mode or when power is restored
after an electrical power outage.
• The remote control will not function properly if
the AC infrared sensor is exposed to direct light
or if there are obstacles between the remote
controller and the air conditioner.
• Default temperature will be minimum 24 °C
(in cooling cycle), when operated with remote
control except power failure/power switched off
Using the Light Off
Function
You can set the brightness of the control panel,
• Press Mode button on the remote control for 3
seconds, or
• Press Mode and Sleep button button together
on the control panel.
NOTE
• Turn on/off the control panel.
Using the Auto Clean
Function
In the Cooling and Dry Mode, Moisture is
generated inside the indoor unit. This function
removes such moisture.
• Press Energy Saver button on the remote
control for 3 seconds.
is displayed on the remote control.
•
NOTE
• If you turn off the unit, the fan continues to run
for 10 minutes and cleans the inside of the
indoor unit.
EN