HP EliteBook 8740W Maintenance And Service Manual page 105

4. Remove the two HM5.0×10.0 screw locks (4) that secure the system board to the base
enclosure.
5. Remove the three Phillips PM2.5×4.0 screws (5) that secure the system board to the base
enclosure.
6. Use the optical drive connector (1) to lift the right side of the system board (2) until it rests at an
angle.
7. Release the system board (3) by sliding it up and to the right at an angle.
8. Remove the system board.
Reverse this procedure to install the system board.
ENWW Component replacement procedures 97