Compaq Contura 400 Maintenance And Service Manual page 111

>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
2. Remove the keyboard assembly (Section 3.7).
3. Remove the system board (Section 3.15).
4. Remove the two screws [1] of the PC Card rails from the bottom of the
system board (Figure 3-60).
5. Loosen the Header screws [2] from the bottom of the system board.
(Figure 3-60).
6. Remove the clip from the top of the PC Card (PCMCIA) header
(Figure 3-60).
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION <<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
Do not over torque the clip, or it can be damaged.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
7. Replacement clips and rails on Models 420 and 430 will look different
but removal and replacement procedures will be the same. To replace the
PC Card clip, reverse the previous steps, making sure that the PC Card