Operating Instructions - Chicago Electric DEMOLITION HAMMER 93853 Set Up And Operating Instructions Manual

Chicago electric power hammer user manual

Hide thumbs Also See for DEMOLITION HAMMER 93853:

Assembly and operating instructions manual (19 pages)

Table Of Contents

Table of Contents

Variable Speed control (72):

Variable Speed Control Dial. The impact rate (BPM) and rotating speed (RPM)

can be varied according to the type of work being performed by setting the

Variable Speed Control Dial to the selected setting: 1-2-3-4-5-6 ("1" Being the

lowest. "6" Being the highest.) The Variable Speed Control Dial may be

adjusted while the Motor is running with the tool free from work, allowing the

operator to adjust the impact rate and rotating speed according to the actual

application.

(See Figure E.)

Auxiliary Handle (104A) and Knob (105):

be supported with the Auxiliary Handle, which can be swiveled 360 degrees.

To reposition and/or swivel the Auxiliary Handle, loosen the Knob. Move the

Auxiliary Handle to the desired position along the barrel of the tool and firmly

retighten the Knob. (See Figure E.)

FIguRE F

Front cap (1) and Slider (4): To install a Chisel (106, 107), clean the insert

shank end of the chisel to remove any debris. Then, lightly grease the shank

with a light oil or grease. Insert the Chisel into the Slider through the Front Cap,

while twisting and pushing inward until the Chisel locks into place. Pull outward

on the Chisel to make sure it is locked into the Slider. (See Figure F.)

WARNINg! Always wear ANSI-approved safety impact eye glasses and

a full face shield when using the Demolition Hammer. Also wear heavy

duty steel-toe boots, hearing protection, dust mask or respirator, and heavy

duty work gloves.

Install a Chisel (106, 107) as previously discussed.

Make sure the Power Switch (66) is in its "OFF" position. Then, connect the

Power Cord & Plug (70) to the nearest 120 volt, grounded electrical outlet.

(See Figure E.)

SKU 93853

For technical questions, please call 1-800-444-3353

The Demolition Hammer is equipped with a

OIL OR gREASE

(NOT INcLuDED)

cHISEL

(106, 107)

cHISEL

(106, 107)

FRONT cAp (1)

SLIDER (4)