Step 4: Connect The Notebook To External Power - HP Compaq NC4200 Getting Started Manual

Step 4: Connect the Notebook to
External Power
To connect the notebook to external AC power:
✎
Power cords and electrical outlets vary in appearance by region
and country.
1. Plug the AC adapter into the power connector 1.
2. Plug the power cord into the AC adapter 2, and then into
an AC outlet 3.
When the notebook receives AC power, the battery pack begins
to charge and the battery light 4 (on the front of the notebook)
is turned on. When the battery pack is fully charged, the battery
light is turned off.
It is recommended that you leave the notebook connected
to external power until the battery pack is fully charged and the
battery light is turned off. (A partially charged new battery pack
can run the notebook after software setup is complete, but battery
charge displays will not be accurate until the new battery pack
has been fully charged.)
Getting Started
Hardware Setup
1–7