Remove the display cable:
1.
Turn the computer right-side up, with the front toward you.
2.
Open the computer as far as possible.
3.
Disconnect the display panel cable (1) from the system board.
CAUTION:
sure you do not pull or damage the cable.
4.
Disconnect the camera and microphone module cables (2) from the system board, and then
remove the cables from the routing path (3).
5.
Remove the wireless antenna cables (4) from the clips and routing channels built into the top cover.
Remove the display assembly:
CAUTION:
prevent damage to the display assembly, support it before removing the screws.
1.
Remove the four slotted Torx T8M2.5×7.0 screws (1) that secure the display assembly to the
computer.
CAUTION:
Be sure you do not pull or damage the cable.
68
Chapter 4 Removal and replacement procedures
There is a ground loop off the display panel cable that is secured to the left hinge. Be
The display assembly will be unsupported when the following screws are removed. To
There is a ground loop off the display panel cable (2) that is secured to the left hinge.