Removing An Optical Disc When No Computer Power Is Available - HP Compaq 6710s User Manual
Hp compaq 6710s: supplementary guide
Hide thumbs
Also See for Compaq 6710s:
- Maintenance and service manual (172 pages) ,
- Specification (28 pages) ,
- User manual (90 pages)
Table of Contents
Advertisement
Removing an optical disc when no computer power is
available
1.
Insert the end of a paper clip (1) into the release access in the front bezel of the drive.
2.
Press in gently on the paper clip until the tray is released, and then pull out the tray (2) until it stops.
3.
Remove the disc (3) from the tray by gently pressing down on the spindle while lifting the outer
edges of the disc. Hold the disc by the edges and avoid touching the flat surfaces.
NOTE:
4.
Close the media tray and place the disc in a protective case.
14
Chapter 6 Using an optical drive
If the tray is not fully accessible, tilt the disc carefully as you remove it.
ENWW
Advertisement
Table of Contents
