Compaq Armada 7300 Command Manual page 57

: 3
(cont.)
+,7( $3(5
.
Pause Command (,)
.
.
This command causes the modem to pause for a specified time during dialing. The duration
.
is set by register S8.
.
.
.
Pulse Dial (P)
.
.
This command sets the dialing mode to pulse. All calls will remain pulse until tone dialing is
.
selected.
.
.
Parameters: none
.
.
.
Return to Command State (;)
.
This command forces the modem to remain in the command state without disconnecting
.
after dialing a number. The semicolon must be placed at the end of the dial command.
.
.
.
Tone Dial (T)
.
.
This command sets the dialing mode to tone. All calls will remain tone until pulse dialing is
.
selected.
.
.
Parameters: none
.
.
.
Wait for Dial Tone (W)
.
. This command causes the modem to wait up to a specified time for the dial tone to occur.
.
The telephone number is dialed immediately upon dial tone detection. This may be helpful
.
when dialing through a PBX or for some long distance services. The maximum wait period
.
is set in register S7.
.
.
.
Wait for Quiet Answer Command (@)
.
.
The modem will wait for at least 210 milliseconds of noise, then 5 seconds of silence in the
.
call-progress frequency band before continuing with the next dial-string parameter. If the
.
modem does not detect the 210 milliseconds of noise and the 5 seconds of silence before the
.
expiration of the call-abort time (S7), the modem will terminate the call attempt with a NO
.
ANSWER message. If busy detection is enabled, the modem may terminate the call with the
.
.
BUSY result code. If the answer tone arrives during execution of this parameter, the modem
.
handshakes.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.