Compaq Armada 7300 Command Manual page 30

NOTE:
Report of Active Telephone
Number may be replaced by the
phrase Phone Ready on some
manufacturers' models.
: 3
(cont.)
+,7( $3(5
.
.
. Display Stored Dial String Option ($Zn?)
.
This command displays the stored dial string from cellular telephone location number n.
.
Display dial string stored in location n.
.
.
Parameter: n = 0
.
.
Displays the last number dialed n = 1 to y (where y = maximum number of storable
.
numbers; telephone specific).
.
.
.
Manufacturer Model ($M)
.
.
This command specifies which cellular phone is attached.
.
Parameters: n = 0, 1, 2, 4
.
.
n = 0 No cellular telephone.
.
.
n = 1 Motorola, JVC, Pioneer.
.
n = 2 Nokia, Technophone, AT&T.
.
.
n = 3 Not supported by this modem.
.
.
n = 4 GE or Ericsson.
.
.
.
Set Cellular $S Register ($Sr=n)
.
Sets cellular $S register r to the value n.
.
.
.
Store Dial String S ($Zn=S)
.
.
This command stores dial string s in the cellular telephone at location number n. When used,
.
the $Z= command must be the last command on the command line. If the string is left
.
blank, location will be cleared.
.
.
Parameter: n = 1
.
.
y = maximum number of storable numbers; telephone specific
.
.
CAUTION: Numbers stored in the cellular phone overwrite any number
.
previously stored in the same location.
.
.
.
Telephone Information Command ($I)
.
This command returns a report of the manufacturer of the cellular telephone, protocol type,
.
.
and active telephone numbers assigned to it.
.
Manufacturer Model Protocol
.
.
Active Telephone Number
.
.
Parameters: none
.
.
.
.
.
.
.
.
.
.