Keypad Operation - Kenwood NX-1200AV User Manual

KEYPAD OPERATION

The keypad operating method can be selected according to the purpose.
None
Channel Entry
OST
Autodial
Even pressing the [ 0 ] ~ [ 9 ], [
button-entry Error Tone will sound and no operation will be
performed.
Press the [ 0 ] ~ [ 9 ] button to enter Channel Entry Mode
and keypad input state.
The following are examples for entering a channel number
by using the keypad.
• If the maximum channel number has 1 digit:
- To make a call on channel 7, press the [ 7 ] button.
• If the maximum channel number has 2 digits:
- To make a call on channel 90, press the [ 9 ] and [ 0 ]
buttons in this order.
- To make a call on channel 7, press the [ 0 ] and [ 7 ]
buttons in this order.
• If the maximum channel number has 3 digits:
- To make a call on channel 250, press the [ 2 ], [ 5 ]
and [ 0 ] buttons in this order.
- To make a call on channel 90, press the [ 0 ], [ 9 ]
and [ 0 ] buttons in this order.
- To make a call on channel 7, press the [ 0 ], [ 0 ] and
[ 7 ] buttons in this order.
If the maximum number of digits is entered, the transceiver
exits Channel Entry Mode and then migrates to the channel
of the entered channel number.
Press and hold the [ 1 ] ~ [ 9 ] button for 1 second, and OST
will be On and OST List number 1 to 9 are selected.
Press and hold the [ 0 ] button for 1 second, and OST
•
will be On and OST List number 1 to 9 are selected.
Press and hold the [
•
Shortcut input of OST List will be appeared.
Press the [ 0 ] ~ [ 9 ] button to enter Autodial Mode.
• If Store and Send is Disabled, Keypad is entered with
Autodial Mode (List Selection).
If Store and Send is Enabled, press [ 0 ] ~ [ 9 ], [ ], [ # ]
•
button is input with Autodial Mode (Manual input).
], [ # ] button, and
] button for 1 second, and
64