NEC DLP Cinema NP- NC2403ML User Manual page 29

Attaching the power cable stopper
To prevent the power cable from accidently removing from the AC IN of the projector, attach the supplied power cable stopper to
clamp the power cable.
CAUTION
• To prevent the power cable from coming loose, make sure that all the prongs of the power cable are fully inserted into the AC
IN terminal of the projector before using the power cable stopper to fix the power cable. A loose contact of the power cable
may cause a fire or electric shock.
• Do not bundle the power cable. Doing this could cause heat or a fire.
• Do not clamp the power cable with other cables. Doing so can generate noise, which can affect adversely the signal
NOTE
cable.
• Be careful not to insert the band inversely. Once the band is attached, it cannot be removed from the slot.
1
With the band of the clamper unit facing the power supply cord, line up the tip of the power
supply cord stopper with the mounting hole in the projector body and press in.
Attach the power cord stopper on the opposite side in the same way.
2
Pass the band through the slits in the power cord stoppers.
Use the two bands to wrap the power cord from the left and right sides.
band
2. Installation and Connection
29