Using Conference; Using Join - Cisco 7920 Series User Manual

• cBarge—Allows you to create a standard (ad hoc) conference by adding yourself to a call on a
shared line. Use the cBarge softkey. cBarge is available only on phones that use shared lines.
• Meet-Me—Allows you to create or join a conference by calling a conference number. Use the
MeetMe softkey.

Using Conference

Conference allows you to call each participant. Conference is available on most phones.
If you want to...
Create a conference
Add new participants to an
existing conference
See a list of conference
participants or remove
participants
End your participation in a
conference
Tips
• Calls must be on the same line before you can add them to a conference. If calls are on different
lines, transfer them to a single line before using Confrn or Join.
• Depending on how your phone is configured, if you leave a conference after initiating it, the
conference might end. To avoid this, transfer the conference before hanging up.

Using Join

Join allows you to combine two or more existing calls to create a conference in which you are a
participant.
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G User Guide for Cisco Unified Communications Manager
FCS REVIEW DRAFT - CISCO CONFIDENTIAL
Then...
1. From a connected call, choose Options > Confrn.
2. Enter the participant's phone number.
3. Wait for the call to connect.
4. Choose Options > Confrn again to add the participant to your
call.
5. Repeat to add additional participants.
Repeat the steps listed above.
Your system administrator determines whether non-initiators of a
conference can add or remove participants.
Choose Options > ConfList. See
Participants, page
Choose
Viewing or Removing Conference
52.
, EndCall, or Options > EndCall.
Basic Call Handling